COSMOSMotion uygulama ders notları

Tüm saatler GMT +3 Saat

Full versiyon Görüntüle

YAZAR: lurhascan
Tarih: 3/8/2017, 13:21

COSMOSMotion Tutorial Page 1
In this tutorial, we will learn the basics of performing motion analysis using COSMOSMotion. Although
the tutorial can be completed by anyone with a basic knowledge of SolidWorks parts and assemblies, we
have provided enough detail so that students with an understanding of the physics of mechanics will be
able to relate the results to those obtained by hand calculations.
Begin by creating the six part models detailed on page 2. For each part,
define the material by right-clicking “Material” in the FeatureManager and
selecting “Edit material.” The Materials Editor will appear, as shown here.
Select “Alloy Steel” from the SolidWorks materials library. The part will
appear with the material color (gray) stored in the library for steel. If you
prefer to show the part with a color that you have defined, uncheck the “Use
material color” box.
Rotation of a Wheel
To begin, we will analyze a simple model of a wheel subjected to a torque. From
Newton’s Second Law, we know that the sum of the forces acting on a body
equals the mass of the body times the acceleration of the body, or
ΣF = ma
The above equation applies to bodies undergoing linear acceleration. For
rotating bodies, Newton’s Second Law can be written as:
ΣM = Iα
Where ΣM is the sum of the moments about a point in the body, I is the mass

[Linki görmek için üye olmanız gerekmektedir]

-> CosmosWorks -> PDA Görünüm - Ana Sayfa
Tüm saatler GMT +3 Saat

Full versiyon Görüntüle

Phpbb PDA Görünüm Tarafindan Yazilmistir.
Writed by © 2004 - 2007 All rights reserved.